速報APP / 生產應用 / Smart Welding Solutions Pro

Smart Welding Solutions Pro

價格:免費

更新日期:2018-03-09

檔案大小:4.7M

目前版本:0.0.2

版本需求:Android 4.1 以上版本

官方網站:http://www.veetrontechnology.com

Email:smartweldingsolution@gmail.com

聯絡地址:Kutch, Gujarat

Smart Welding Solutions Pro(圖1)-速報App

Instant solution for various joint Configurations /designs

Weld deposit weight Calculation ( by default steel )

Volume calculation

Cross Section Area Calculation

Smart Welding Solutions Pro(圖2)-速報App

Surface opening calculation

Instant Comparison of weld deposition; volume; cross section areas; surface opening w.r.t to different angles.

Weld deposition weight calculation of other materials also feasible by change of respective material density.

Welding consumable weight calculation

Smart Welding Solutions Pro(圖3)-速報App

Welding Time calculation

welding consumable cost calculation

Processing Cost calculation

Mandays calculation

Smart Welding Solutions Pro(圖4)-速報App

Carbon equivalent calculation

Heat Input Calculation

Tube to Tubesheet expansion calculation

Groove design in such a way that it can calculate almost all feasible welding joint configurations instantly

Smart Welding Solutions Pro(圖5)-速報App

There is provision of pdf conversion of all the values. That can be transferable to others.

Joint configurations included in this app are grooves, fillets, ESSC and Hard facing or built up.

Further, Groove Joint configuration- single bevel, double bevel, straight face, single V, Double V, Single J, Double J, Single U , Double U, tube to tube sheet joint , (TTJ), square joints ( by change of grove angle 0 degree ) etc. these are covered almost all type of groove designs.

There is universal groove joints configuration section, which is designed for almost all groove joint which can be generated with maximum double taper angles from both sides. Based on the inputs, you can get desired groove and results.

Smart Welding Solutions Pro(圖6)-速報App

If any joint configuration is not covered in that, you can get divide into small joint configuration ( daughter grooves), which are covered in this application.

In that case you will get adequate information to get desired results. Eg:

1. Surface opening (1/2) of one daughter groove shall be root gap of other daughter groove.

2. Weld reinforcement shall not be considered when one daughter groove is covered with other daughter groove.

Smart Welding Solutions Pro(圖7)-速報App

3. It is advise to make groove drawing and carefully define welding terms for each daughter grooves. Ensure for inputs for individual grooves and results received on this shall be recorded and subsequently used for further calculation and input for other daughter grooves as required.

The calculation has been done in such a way that results are higher side from conventions calculation. There are some assumptions are used in calculation . There may be difference in results from various practices used in welding industries.

This may contain third –party advertisements that may redirect you to third party site.

Smart Welding Solutions Pro(圖8)-速報App